1.Preparation:2KG grout ;5kg ceramic tile adhesive ; paving tool ;grout tool.

Mix:Water with ceramic tile glue together

Glue:For tile adhesive or white cement wall plastering leveling,hit good base,and ensure that the temperature ranged from 5ºC to 39ºC Celsius.

2.Sticking preparation:

(1)The base and guarantee smooth surface,and then use the net paste paving in the wall or floor.

Attention:tile adhesive or white cement plaster ,must be tidy.

(2)Paving the mosaic neatly on the wall with hand ,ensure that each combination and wall integrity.Each posting a mosaic,with sealant shot in prison,ensure each are fully combined compaction and adhesive.

3.Caulk

Caulk to try to use the sealant,caulking tool need to move diagonally, From bottom to top, then from top to bottom,and scraping pulp ,must be full, at the same time to ensure every time the pulp scraping area of not more than 2m2, ensure the sealing agent all can completely fill and no residue,otherwise it will cause difficult to clean.

Attention:mosaic slit does not fill the future easy to accumulate dust,clean and difficult.so mosaic slot must be filled full.

Attention:Mosaic with cold spray/mirror/electroplating crafts can not use the white and black cement when paving.The alkalinity of cement will corrosion mosaic particles. The mosaic will change color and fall off, must use mosaic special agent  or neutral sealant.

4.Clean

Caulk good about 20 to 25 minutes after can be used in cleaning.Generally use a wet sponge to clean,try not to be too strong,lest they will wipe already filled in the seam sealant.Finally with a dry cloth to wipe.

Attention:Be careful not to put the crevice of the sealant also scratches.You can be use wet cloth,damp sponge.

5.Daily protection

Usual routine can be cleaned with water.If the event of stubborn stains can be use weak acid and ethyl alcohol.But after cleaning must be immediately with plenty of water for cleaning.

Attention:it is not suitable to use detergent(alkali) to clean electroplating mosaic.