Treating surface: we set aside more than mosaic about 3 mm thickness , and do a full clean-up work before paving.

Pre-pave: we should make the pre-pave according to picture of installation, if it is the larger area we can combined with schematic stitching.

Paving: we use special adhesive evenly to the base layer, the thickness of 2 mm is appropriate. The single joint mosaic aligned slit in accordance with the drawings, the brush is placed on good adhesive. Then planks flat on the mat mosaic surface evenly with a rubber hammer strokes, proper bonding.

Pointing: until the water dries up and have a moderate initial strength, use a wooden or rubber spatula make grouts poured into the gap in the mosaic. Until grouts filling is completed, the water dries and has moderate intensity ,we can start with an initial clean up.