When all the walls to be finished paving, the adhesive layer is finished the final setting, and after pointing is finished, do a check again,We can use the clean wet and soft brush clear away the left floating in the mosaic crack. 

 

2.Do well in Air-dried

When finished the paving, we should pay attention to the protection of the finished product, it may be suitably dried. In just finishing pave ,the surface should avoid sun exposure, indoor should be proper ventilation .It is maintained until about 24 hours after the hand over, the Later maintenance shall be more than seven days.

 

3.clean

When the adhesive layer and the final setting pointing mortar, we can start cleaning Mosaic. Cleaning need two buckets, one hold new freshening agent, and other one hold  clean water, first we wet rag in the bucket with new freshening agent , do not wring dry, then wipe Mosaic in circular manner ,and then we wet sponge in the second bucket with clean water, then use sponge to wipe the mosaic surface, wipe off any residue. Finally, wipe the surface again with a sponge until clean.

 

4.Install the switch socket

After making paving become dry , we need to remove the power to switch and socket re installed. Thus, the working procedure paving wall mosaics is successfully completed.